Trims and doors are painted with enamel because they take much more wear than walls. Skirtings are kicked and vacuumed, door edges are handled every day, and window frames deal with condensation and sun. Enamel dries to a harder, smoother and more washable film than ordinary wall paint, so it stands up to that treatment and cleans easily without going patchy.
What makes enamel different
Enamel is a paint formulated to dry hard and level out smoothly. Compared with wall paint, it has a higher proportion of binder and resins designed for toughness, and it usually comes in higher sheen levels. That combination gives a surface that resists scuffs and can be cleaned repeatedly.
The term covers both water based and solvent based products. Traditionally, enamel meant a solvent based alkyd gloss. Today, most trims and doors in Australian homes are finished in water based enamel, which has improved a great deal.
Water based or solvent based enamel?
- Water based enamel: low odour, quick to recoat, cleans up with water and stays white over time. It is a little softer in the first weeks while it cures, and needs good technique to avoid brush marks.
- Solvent based enamel: levels out to a very smooth, hard finish, but has strong fumes, takes much longer to dry, needs mineral turps to clean up and tends to yellow, especially in darker rooms and behind doors.
Our comparison of water based and oil based paint goes through the differences in more depth. For most interior trims and doors, water based enamel is now the sensible default.
Choosing a sheen level
Enamel comes in several sheens, and the choice is partly practical and partly a matter of style:
- Satin: soft and modern, a good choice when trims are painted the same colour as the walls, and forgiving of minor flaws.
- Semi gloss: the most common choice in Australian homes. Durable, easy to wipe, with a clean look against low sheen walls.
- Gloss: the most hard wearing and traditional, and it suits period joinery in villas and bungalows, but it shows every dent, brush stroke and bit of dust.
Higher sheen also makes a colour look slightly lighter, so a trim in the same tint as the wall will read a little crisper. That subtle contrast is usually a plus.
Preparation makes or breaks it
Enamel exaggerates whatever is under it. A dent, a gap, a lump of old drip or a bit of dust will be obvious once a glossy finish goes over it. Good enamel work usually involves:
- Cleaning to remove grease and grime, especially on door edges and around handles.
- Filling dents and gaps with suitable filler and flexible gap sealant where trims meet walls.
- Sanding to smooth repairs and to dull existing gloss so the new coat grips.
- Priming bare timber and using an appropriate undercoat over old solvent enamel when switching to water based.
- Removing dust before each coat.
In older homes, old enamel layers may contain lead. Do not dry sand old paint without checking first and following SA Health guidance.
Applying it well
Enamel needs a steady hand. Coats should be thin and even, laid off in one direction along the length of the timber, and not overworked as they begin to set. Doors are painted in a set order, panels first and then rails and stiles, so wet edges do not dry into visible marks. Our guide to getting a smooth finish on interior doors covers that sequence.
Allow plenty of time between coats and before closing doors fully, because fresh enamel can stick to frames. Check the tin for recoat times, as they vary between products.
Worth getting right
Fresh, smooth trims and doors make a whole room look finished, even when the walls are only lightly refreshed. They are also among the most time consuming parts of a repaint because of the detail involved. If your skirtings, architraves and doors are chipped or yellowed, they can be included in our interior painting work, with the enamel and sheen chosen to suit your home.