Exterior paint peels when it loses its grip on the surface underneath. The four most common causes are moisture getting behind the paint, poor preparation, incompatible coats such as acrylic over old oil based enamel, and painting over a chalky or dirty surface. The fix always follows the same pattern: find the cause, remove everything loose, deal with the cause, then prime and repaint.
Moisture behind the paint
Water is the most common reason paint peels on Adelaide houses. It gets into timber or masonry, then tries to escape through the paint and pushes it off in blisters and flakes. Common sources include:
- Leaking or overflowing gutters soaking fascias and walls.
- Gaps around windows and doors where sealant has failed.
- Rising damp at the base of masonry walls in older homes.
- Bare end grain on timber that was never primed.
- Sprinklers, garden beds and soil built up against walls.
- Paint applied to timber or render that had not dried after rain or washing.
Moisture related peeling often shows as paint lifting all the way to bare timber or render, with the exposed surface looking clean. It tends to start at the base of walls, on sills and around joints.
Poor preparation
Paint bonds to whatever it lands on. If that is dust, cobwebs, a loose old coat or a slick glossy surface, the new paint is only as strong as that layer. Signs of a preparation failure include paint peeling in sheets that bring dirt or older coats with them, or new paint lifting cleanly off a shiny surface underneath. Proper prep means washing, scraping loose paint, sanding edges and glossy areas, and priming bare spots. Our post on why preparation matters explains where the time on a good job really goes.
Incompatible coatings
Many older homes have trims and doors finished in solvent based enamel. Over the years it hardens into a glossy, brittle shell. Water based acrylic applied straight over it often fails to bond and can be peeled away in strips, sometimes with a fingernail. The cure is to sand the old enamel to a dull finish and apply a suitable adhesion primer before the topcoats. Our guide to painting over gloss includes a simple test for old enamel.
The opposite problem happens too. A rigid coating over a flexible one, or hard enamel over a soft, chalky base, can crack and lift as the layers move at different rates.
Chalky surfaces
Old exterior paint breaks down into a fine powder at the surface. Painting over that powder is like painting over flour: the new coat sticks to the chalk, not to the wall. This usually shows as wide sheets of new paint lifting a year or two after the job. Chalk needs a thorough wash and, if a wipe test still shows powder, a binding primer made for chalky surfaces.
Other causes worth knowing
- Painting in heat or direct sun, which leaves a weak, poorly formed film.
- Too many layers. Decades of coats build into a thick, brittle crust that eventually cracks and lets go, often taking several layers with it.
- Galvanised metal painted with the wrong primer.
- Salts in masonry, where crystals forming under the paint push it off from behind.
Fixing it so it stays fixed
Patching peeling paint without tackling the cause just repeats the problem. The usual approach is to stop the water first, then scrape back to firmly bonded paint, feather the edges, let the surface dry, prime bare areas with a primer that suits the substrate, fill and seal gaps, and apply two topcoats. Where layers are thick and failing widely, stripping back to bare timber may be the only lasting fix. On older homes, find out whether lead is present before sanding or scraping large areas; SA Health has general guidance. A simple check after the job: once the paint has cured, press a strip of masking tape firmly onto a test area and pull it off sharply. If paint comes away on the tape, adhesion is poor and the cause has not been solved. On a sound job the tape comes off clean.
Our exterior painting team can work out why your paint is peeling before recommending a repair.