Streaks on a ceiling almost always come from paint drying at different rates across the surface, or from roller marks that catch the light. To avoid them, use a flat ceiling paint, work in strips small enough that the edge stays wet, finish every strip with light strokes in the same direction, and apply two even coats rather than one heavy one. Do that and most ceilings come up clean and uniform.
Why ceilings show every mistake
Light from a window travels along a ceiling at a very shallow angle. That raking light picks up texture, ridges and changes in sheen that would be invisible on a wall. A ceiling can look perfect when you are standing under it with the lights on, then show stripes the next morning when the sun comes through the window.
The two main culprits are lap marks, where wet paint was rolled over paint that had already started to dry, and uneven film thickness, where some areas got a heavier coat than others. Both show as bands or patches of slightly different sheen.
Start with the right paint
A purpose made ceiling paint is flat, which means it reflects very little light and hides small differences in texture. Many ceiling whites also have a longer open time, so they stay workable for a little longer before setting. Using leftover low sheen wall paint on a ceiling is a common cause of streaking, because any sheen at all makes lap marks easier to see.
If the ceiling has water stains, smoke marks or old patches, spot prime them with a stain blocking primer first. A topcoat alone will not hold back a stain, and a patch that soaks up paint differently will show as a dull spot however carefully you roll.
Keep a wet edge
The single most important technique is keeping a wet edge. That means each new section of paint is rolled into the edge of the previous section while it is still wet, so they blend into one continuous film.
- Cut in the edges around the cornice and light fittings first, but only a section at a time, so the cut in is still wet when the roller reaches it.
- Work in strips about a roller width or two wide, running across the shorter dimension of the room so each strip is finished quickly.
- Do not stop halfway across the ceiling for a break. Finish the coat, then rest.
- On hot Adelaide days, close the blinds, avoid fans blowing across the ceiling and start early. Fast drying is the enemy of a wet edge.
Roller technique
Use a good quality roller with a medium nap, suited to the ceiling surface, on an extension pole. Load it evenly from a tray or bucket with a grid, so it is full but not dripping. Apply the paint in a zigzag or W pattern to get it onto the surface, spread it out across the section, then lay off.
Laying off is the final pass: a light stroke with an almost empty roller, all in one direction, from the wet edge into the new paint. Many painters lay off ceilings towards the main source of light, so any faint roller texture runs in line with the light rather than across it. Do not press hard to squeeze out the last of the paint, because that is how you get ridges at the roller ends and thin, streaky spots in between.
We go into rolling technique in more depth in how to roll a wall for an even finish, and most of it applies overhead as well.
Two coats, with the right gap
The first coat will often look patchy as it dries. That is normal and not a reason to go back and touch it up while it is wet, which only makes things worse. Let it dry fully, then apply a second coat in the same way. Recoat times for ceiling paint are commonly a few hours in mild weather, but check the tin and give it longer if the room is cold or damp.
Between coats, look at the ceiling from different spots in the room and with the blinds open. Any drips, bits of roller fluff or ridges can be lightly sanded back before the second coat goes on.
Do ceilings first
Ceilings are normally painted before walls, because drips and spatter fall downwards and the wall coats then tidy up the line at the cornice. If you are working out the order for a whole room, our article on whether to paint the ceiling or the walls first explains the full sequence.
Ceilings are hard on the neck and shoulders, and big or high ones need proper access. If you would rather leave it to someone else, our interior painters can do the ceilings alone or as part of a full room.