Timber window frames last longest when the sills get the most attention. Sills take rain, sun and standing water more than any other part of the frame, so they are where paint fails first and rot begins. A good repaint scrapes and sands back to sound timber, repairs rot, replaces loose glazing putty, primes bare wood and finishes with an exterior enamel or acrylic, while keeping the sashes able to open.
Why sills fail first
A sill is a horizontal ledge sticking out from the wall. Rain lands on it and runs across the top, sun bakes it from above, and water soaks into the end grain at each side. The joint where the sill meets the frame is a favourite entry point for water. On north and west elevations the paint cracks along the grain within a few years, water gets in, and the timber swells and rots from inside. Press a screwdriver into the ends of the sill; if it sinks in, there is rot.
Preparing the frames
Start by knowing what you are working with. Many windows in Adelaide villas and cottages are original, so the lower layers of paint may contain lead. Do not dry sand or heat strip old frames until you know. Our guide to lead paint in older homes and SA Health's general guidance explain the precautions.
- Scrape loose and flaking paint, then sand the edges smooth. Hand sand mouldings so crisp profiles are not rounded off.
- Dig out rotten timber and repair small areas with a two part exterior timber filler, or splice in new timber for larger ones. Badly rotted sills may need replacing.
- Prime all bare timber with an exterior timber primer, giving end grain extra attention.
- Seal gaps between frame and wall with a paintable exterior sealant.
Glazing putty
On older timber windows the glass is held in with putty bedded into a rebate. Over time the putty dries, cracks and falls away, letting water in behind the glass. Cracked or loose putty is removed carefully, the rebate primed, and new putty applied and left to firm up before painting; check the product for how long. When painting, the paint should lap a millimetre or two onto the glass to seal the join between putty and glass. That slight overlap on a straight line is a sign of good work, not a mistake.
Sticking sashes
Double hung sash windows, common in older Adelaide homes, are often painted shut over the years. Paint builds up in the channels and on the sash edges until they jam. When repainting:
- Free stuck sashes by cutting along the paint line rather than forcing them.
- Sand back paint build up on the running edges and sides.
- Keep paint off the surfaces that slide against each other and off the sash cords.
- Move the sashes up and down a few times as the paint dries so they do not set shut.
Casement and awning windows need hinges and stays kept clean, and the sash edges painted thinly so they still close properly.
Finishes for window frames
Window frames are traditionally finished in gloss or semi gloss enamel, which sheds water and resists dirt. Water based exterior enamels are now widely used, as they stay more flexible and resist yellowing. Two coats are standard. Paint in a sensible order: the inner parts of the sash first, then the outer frame, and the sill last, so you are not reaching over wet work.
Choose a calm, dry day and avoid painting late in the afternoon, so the sills are not caught by dew before they dry.
Looking after them
Check sills and the bottom rails of sashes each year, and touch up any crack or chip before water gets in. Frames on the sunny side may want a maintenance coat between full repaints. If your windows sit in a timber clad house, see our guide to painting weatherboards, and our exterior painting team can repair and repaint old frames as part of a larger job. A free quote includes a look at the condition of the timber.