100% satisfaction guarantee /Painters across metropolitan Adelaide

Interior Painting

Can You Paint Kitchen Cabinets?

Yes. Timber, painted and most laminate cabinets can be repainted with thorough degreasing, sanding and a bonding primer. Peeling vinyl wrap and damaged board are the exceptions.

Kitchen with white painted cabinets, a stainless steel microwave above a white gas cooktop and a white fridge

Most kitchen cabinets can be painted, and it is one of the biggest visual changes you can make to a kitchen without replacing it. Solid timber, previously painted MDF and many laminate doors all take paint well when they are prepared properly. The doors to be wary of are vinyl wrapped fronts that are already peeling and particleboard that has swollen from water. The finish will only be as good as the surface underneath it.

What are your cabinets made of?

The material decides the preparation:

  • Solid timber: paints very well. Clear finished timber needs the old varnish dulled and a primer suited to the timber, and some species need a stain blocking primer so tannins do not bleed through a pale colour.
  • Painted MDF or two pack doors: usually an excellent base. The existing finish is hard and glossy, so it needs sanding and a bonding primer.
  • Laminate and melamine: can be painted with the right adhesion primer. The surface is slick and non-porous, so skipping the primer is the main reason laminate paint jobs chip.
  • Vinyl wrap: a thin plastic film heat formed over MDF. If it is lifting at the edges, painting over it will not stop it lifting further. The fronts are better replaced.

Check the cabinet boxes too. Water damage under the sink and swollen edges near the dishwasher are common and need repair before painting.

The preparation that makes it last

Kitchen cabinets carry a film of cooking grease, hand oils and cleaning residue, often invisible until paint refuses to stick to it. Thorough degreasing is the single most important step, with special attention around handles, under the overhead cupboards near the cooktop and along the edges of drawers.

A typical sequence looks like this:

  1. Remove doors and drawer fronts, label each one and its hinges so they go back in the same place.
  2. Remove handles and hardware.
  3. Degrease, rinse and dry.
  4. Fill dents and old handle holes if changing hardware, then sand smooth.
  5. Scuff sand all surfaces to dull the sheen, then remove every trace of dust.
  6. Apply a bonding or adhesion primer suited to the material.
  7. Apply two coats of a hard wearing enamel, sanding lightly between coats.

Our article on painting over gloss explains why the primer step cannot be skipped on slick surfaces.

Spray, brush or roller?

Spraying gives the smoothest, closest to factory finish, with no brush marks in the flat panels. Doors are usually sprayed off site or in a protected area, laid flat to avoid runs, and given time to dry before handling. The cabinet boxes and face frames that stay in place are often brushed and rolled with a fine foam or short nap roller, because spraying inside a kitchen needs extensive masking.

A brush and roller finish can still look very good, especially on shaker style doors where the profile hides a little texture. It will not be quite as flat as a sprayed finish, so it suits people who are happy with a hand painted look.

Choosing the paint

Cabinets need a hard, washable enamel in satin, semi-gloss or gloss. Water-based enamels are now the common choice because they stay white rather than yellowing and are low in odour. Oil-based enamels flow out to a very smooth finish and cure hard, but they yellow over time, particularly in darker areas. Our guide to enamel paint for trims and doors compares them in more detail.

Durability and the first few weeks

Enamel feels dry within hours, but it takes much longer to cure to full hardness, often several weeks depending on the product and the weather. Check the tin. During that time the paint can mark if handles are screwed on too tightly, doors are slammed, or wet cloths are left draped over them. Fitting small buffers to door backs helps prevent sticking and chipping where doors meet the frame.

Once cured, a well prepared painted kitchen holds up well to normal use. Edges around handles and the doors under the sink and near the bin take the most wear, so a small tin of the exact colour is worth keeping for touch ups.

Cabinet painting sits within our interior painting service, and at the site visit we can check the door material, the condition of the boxes and whether paint is the right answer for your kitchen.

Keep reading

Related guides

All articles

Free quotes

Want it done properly, first time?

Prefer to leave it to the professionals? We quote every job free, after a site visit.

Call us Free quote